Dante Virtual Soundcard allows your PC or Mac to connect to a Dante audio network. Dante Virtual Soundcard uses the Ethernet port on the computer to communicate with a network of other Dante enabled devices. No auxiliary hardware is required. Audio applications use the Dante Virtual Soundcard as they would any standard ASIO, WDM or Core Audio What I'm looking for is the best way to actually interface a computer with this mixer via Dante, ideally to capture up to 64 channels, again at 96kHz. I use a Mac currently for recording, and am not looking to switch. The simplest option seems to be the Dante Virtual Soundcard (DVS), but that's limited to either 64 channels at 48kHz or 32 at 96kHz. Manage Licenses. Dante Virtual SoundcardPC and Mac: Meet Dante Turn your PC or Mac into a Dante-powered workstationRead More Read More Dante ControllerReal-Time Network Monitoring Free software application that enables you to route audio and configure devices on a Dante network.Read More Read More Dante Domain ManagerSupercharged Dante Network Dante is a network protocol and doesn't care about what type of NIC it's outputting to. It works on 100Mb, 1 Gbe or 10Gbe. I've gone to their in-person certification classes and in those classes they state explicitly that 10 Gbe networks actually run Dante faster. It works 100%. Audio interface >>> Dante Controller Software. Your Computer >>> Dante virtual Soundcard. The Dante Controller software is your “hub” where all interfaces and computers connected to your switch are seen, and configured. Including the sample rate, and which ins go to which outs. Once this is set up, you get: Nuendo. /. DSCP 46 - Dante Audio - Medium Priority Everything Else - Best effort. Video is typically far more tolerant of packet jitter than audio, as for audio the timing windows are deliberately kept much smaller. Also, because Dante is a clock synchronize protocol, disruption to the clock packets can cause severe artifacts affecting your audio network. According to their latest offering, a combo pack of Via and Virtual Soundcard: "Dante Via supports up to 16x16 channels of audio for each application and up to 32x32 for each connected device." Audinate's new Dante Software Combo Pack delivers two licenses for only $59.95. If I'm reading this right Via could have at least 16 virtual outputs Dante Virtual Soundcard is enabled The initial Dante Setup for the console has DVS selected as device #3. After Dante Virtual Soundcard (DVS) has been enabled, the QL console should automatically recognise that the PC has been connected to the network (assuming only a single PC with DVS running is connected). A message “I/O fMHtF0.